Install the frame to radiator braces. Refer to factory specifications for specific requirements. Refer to Lifting and Jacking the Vehicle. Refer to Starter Motor Replacement. This tool holds the lower half of the centering sphere while the upper half is rotated thus winding the spring.
Position the crankshaft balancer 138 onto the end of the crankshaft. Kent-moore allison transmission tool set genuine oem special service just like the dealerships use. Kent-moore gm spxcover alignment pin setj-44219applications: 2002 gmt360 chevy trail blazer, gmc envoy, olds bravada j is a pair of pins used to support the cover enabling technician smooth glide onto engine. Refer to Engine Splash Shield Replacement. This tool is applicable to 1990 and later Ford Aerostar, Ford Explorer, Ford Bronco, 1991 and later E and F Series, 1992 and later Ford Ranger and 1994 and newer Saab 900 sedans.
Important: The nose of the crankshaft should be recessed 2. Please review the updated and accept changes. Install the front lower air deflector. Connect the transaxle cooler lines to the transaxle. The bolts holding these pulleys are extremely tight and without the 64700, removal is extremely difficult at best. Fast delivery service , correct part , excellent prices.
This item may not be in stock; please email service toolsource. It must be removed by pulling directly on the hub, not on the outer edge of the balancer. The countershaft rear bearing requires a great deal of force over a large span to remove, and must be removed before the countershaft can be taken out of the transmission case. The first pass ensures that the balancer is installed completely onto the crankshaft. Refer to Automatic Transmission Oil Cooler Hose Replacement. Remove the balancer installation tool.
Tighten Tighten the bolt to 75 N·m 55 lb ft. This is all info I got from my gm service manual. It must be drawn squarely into the bore of the front cover and carefully to avoid damage to the inner lip. Refer to Drive Belt Replacement - Accessory. Manufacturer Part Number: J-41816-3 , Brand: Kent-Moore Review mpn: j-41816-3 for sale J-41816-3 Kent-moore 41816-3 Gm Puller Leg Set 2004 Up T Truck Sku: hscr10-lh-15078. They were the only company who offered the part I was looking for to repair a tool.
Refer to Automatic Transmission Oil Cooler Hose Replacement. Refer to Intermediate Steering Shaft Replacement. Install the J 41816 1 and the J 41816-2 2 , to the crankshaft balancer. J-22912-01 is placed around the countershaft rear bearing, wi. Refer to Starter Motor Replacement. Install the right front tire and wheel assembly. If the balancer is not installed to the proper dimensions, install the J 41665 and repeat the installation procedure.
J-8433 is used with previously essential J-22912-01 Bearing Remover to remove the countershaft rear bearing. Use a second wrench and rotate the installation tool nut clockwise until the balancer is installed onto the crankshaft. Install the transmission bellhousing bolt located at approximately the 10 o'clock position when looking from the rear of the engine. With the two sphere halves in there proper. Refer to Engine Support Fixture.